Timer-to-Close allows programming in 5-sec or 1-min increments.
Commercial or industrial photo-eyes required.
Thermal motor overload can be easily reset from the 3-button floor level control
station
Reliability & Programming Simplicity
Switchless motor eliminates stuck start switch and motor malfunctions
on single-phase operators
All high-voltage connections have been removed from the board
for safety and ease of service
Diagnostic LEDs speed installation and troubleshooting
Motor direction jumper lets you change motor direction by simply
moving a jumper
Mechanical Reversing Contactor Circuit
(M): (115V, 208/230V,
460V, 575V, 24V NEC Class 2 Circuit with 40VA transformer) Industrial
linear contactor provides significantly longer control runs
than conventional contactors.
Standard Features
Motor: Continuous-duty high-starting torque motor with instant
reverse and overload protection. Available in 1/3, 1/2, 3/4
and 1 HP; single- or three-phase. Removable without affecting
limit switch settings.
Drive Reduction: First-stage heavy-duty 5L V-belt; second stage
and output on trolley #41 chain.
Emergency Disconnect: Spring-loaded for emergency manual operation.
Wiring Type: B2, C2, D1 and E2 wiring types are standard and
easily set using a selector dial on the Logic 3.0 Control Board
(L3). T and TS wiring can be activated with use of a CPS-L or
CPS-LN4. Reversing Contactor Units (M) have C2 wiring standard
and B2 available by simply moving a jumper wire. Operators are
pre-wired to accept a sensing edge, photoelectric sensors, radio
controls and most types of access control equipment. Failsafe
wiring can be selected with use of a CPS-L, CPS-LN4 or failsafe
edge and CPS3 card.
External Radio Control Terminal: Quick, convenient connections
for retrofitting or adding radio controls on logic or mechanical
operators.
Brake: Solenoid-actuated brake is standard.
Bearings: Ball bearings on output shaft; heavy-duty, oil-filled
bushings on reduction shafts.
Friction Clutch: Adjustable, helps protect against major damage
to door and operator should the door meet an obstruction.
Construction: NEMA 1 type electrical box, heavy-duty 11-gauge
steel frame with durable powdercoat finish, all reduction sprockets
drilled and pinned to shafts.
Push Button Station: 3-button station comes standard and has
open/close/stop functionality.
Rail Assembly: High-strength dual L-rail track and quick-mount
header bracket which provides fast, swing-up installation.
Control Accessories
CPS® Commercial Protector System®: (recommended) A “non-contact”
photo safety sensor designed to sense an obstruction and signal
the door operator to reverse to open.
Sensing Edge: (recommended) Designed to sense an obstruction
and signal door operator to stop or reverse as desired. Either
an electric or pneumatic sensing device can be added to bottom
edge of door.
Bi-Parting Door Hardware: Modification includes hardware to
use Model SD on bi-parting door.
Available Plug-in Options for Logic 3.0 (L3)
Auxiliary Contact: Used to operate security, warning, heating
or other 5V to 240V devices. Features both normally open and
closed contacts that actuate in conjunction with limit switches.
Warning Signal: Red/green light module provides safety warning
prior to close (when using timer-to-close feature). System also
supports audio warning devices and includes down mid-stop feature.
CPS3 Option: Enables the addition of a second set of photo-eyes
or 2- or 4-wire, self-monitoring edge.
